Color Customization Ultra-Thin Powder Coating

• CAS No.: Ep2011
• Color: White
• Appearance: Powder
• Main Raw Material: Polyurethane
• Paint Film Property: Insulating Varnish
• Method: Spray
• Level: Finish Coat
• Category: Organosilicon Heat-Resistant Lacquer
• Certification: ISO9001, ISO14001, CCC, RoHS
• Substrate: Iron
• Components: Film Forming Matter
• Formation Mechanism: Conversion Type
• Curing Condition: 180-200 Degree/8-10 Minutes
• Gloss: High Gloss, Low Gloss
• Transport Package: Packed in Cartons, Lined with Polyethylene Inner B
• Specification: 20 kg
• Trademark: City Star
• Origin: Anhui, China
• HS Code: 3208909090
• Production Capacity: 50000

Product Description

1. General introduction
     This product is composed of resin and hardener, which can be used for aluminum, pipes, and rolls
Coating of steel and other products, etc.
2.Products
      Powder coatings are available for both indoor and outdoor applications.
3.Physical properties
     Specific gravity (25°C.g/cm'): 1.2-1.8 Particle size distribution: 100% less than 100 microns (can be adjusted according to the special requirements of coating)
4.Curing conditions
      200°C/10min (solid temperature)
5.Average coverage
     8-10 m²/kg, film thickness 60 microns (to 100% powder coating
Usage Calculation)
6.wrap
     Packed in cartons, lined with polyethylene inner bags, net weight 20 kg per carton.
7.Storage requirements
     Store in a ventilated, dry and clean room below 30 °C, not close to fire and heating, avoid direct sunlight, and it is strictly forbidden to stack it in the open air. Under these conditions, the powder can be stored stably for 90 days. After the storage period, the test can be re-conducted, and if the results meet the requirements, it can still be used.
8.Health & Safety
     This powder coating is a non-toxic product, but dust inhalation should be avoided during use. It is recommended that operators wear appropriate dust masks and glasses.
9.other
     This technical information is for the user's reference only, and the specific indicators are detected under certain conditions.




                                                                                             Coating performance
 

Test items	Inspection standards	Test indicators
Impact strength	GB/T1732-1993	50kg/cm
Cupping test	GB/T9753-1988	8mm
Adhesion (grid method)	GB/T9286-1998	Level 0
Pencil hardness	GB/T6739-1996	1H-2H
Salt spray test	GB/T1771-1991	> 500 hours
Concentrate:   1. The above test uses 0.8mm thick derusting, degreasing cold-rolled steel plate, and the thickness of the coating film is 35-45 microns                                        2. The performance indicators of the above coating film may change with the change of color.